AEM 30-8444 Gauge Boot - Manual

ADVANCED ENGINE MANAGEMENT INC.
2205 126 th Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
www.aemelectronics.com
Instruction Part Number: 10-8444 Rev 1
 2010 Advanced Engine Management, Inc.
1
AEM's Universal Gauge Boot acts like a wet suit or shower cap for virtually any 52mm gauge. It
is made of silicone rubber and is designed to stretch onto the back of the gauge cup while
keeping dust, water, dirt, and mud out of the back of the gauge when installed correctly.
!!Please note: The installation of this Gauge Boot does not make the gauge waterproof!!
1. Insert the gauge harness/harnesses into the tubular snoot of the boot. See Figure 1
below. The gauge boot is made from silicone rubber and will stretch some. However, it
is recommended that the unterminated end of the harness or the smallest connector be
passed through the snoot. Note: Use caution during assembly as sharp objects can
pierce the boot.
2. Connect the harness/harnesses to the gauge and pull the boot over the gauge cup. It
may be helpful to turn the boot inside out and roll it onto the cup, inserting the
mounting studs first. See Figure 2 below.
Installation Instructions for PN: 30-8444
Universal Gauge Boot for 52MM (2 1/16”) Gauges
Figure 1. Insert Harnesses
Figure 2. Installed Boot