AEM Infinity Supported Applications - GM LSX 58X Engine - Manual (Page 10)

10
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest. Pin GM LS Hardware Specification Notes
C1-51 VR-_In_3
Driv en Lef t
Wheel Speed
Sensor - Dif f erential Variable
Reluctance Zero Cross
Detection
See Driv en Wheel Speed
Calibration in the Setup Wizard
Input Function Assignment page.
C1-52 VR+_In_3
Driv en Lef t
Wheel Speed
Sensor +
C1-53 DBW1 Motor -
DBW Motor
Control Close
5.0A max Throttle Control
Hbridge Driv e
+12V to close
C1-54 DBW1 Motor +
DBW Motor
Control Open
5.0A max Throttle Control
Hbridge Driv e
+12V to open
C1-55 Power Ground Ground Power Ground
Connect directly to battery
ground.
C1-56 Injector 6 Injector 6 Fuel Injector 6 Control
Saturated or peak and hold,
3A max continuous
Injector 6
C1-57 Injector 5 Injector 5 Fuel Injector 5 Control
Saturated or peak and hold,
3A max continuous
Injector 5
C1-58 Injector 4 Injector 4 Fuel Injector 4 Control
Saturated or peak and hold,
3A max continuous
Injector 4
C1-59 Injector 3 Injector 3 Fuel Injector 3 Control
Saturated or peak and hold,
3A max continuous
Injector 3
C1-60 Power Ground Ground Power Ground
Connect directly to battery
ground.
C1-61 +12V +12V In Powertrain Relay +12V 12 v olt power f rom relay
12 v olt power f rom relay . Relay
must be controlled by +12V
Relay Control signal, pin C1-29
abov e.
C1-62 Injector 2 Injector 2 Fuel Injector 2 Control
Saturated or peak and hold,
3A max continuous
Injector 2
C1-63 Injector 1 Injector 1 Fuel Injector 1 Control
Saturated or peak and hold,
3A max continuous
Injector 1
C1-64 +12V +12V In Powertrain Relay +12V 12 v olt power f rom relay
12 v olt power f rom relay . Relay
must be controlled by +12V
Relay Control signal pin C1-29
abov e.
C1-65 +12V_SW Ignition Switch 10K pulldown
Full time battery power must be
av ailable at C1-10 bef ore this
input is triggered.
C1-66 Analog_In_Temp_1
Coolant Temp
Sensor
Engine Coolant
Temperature Signal
12 bit A/D, 2.49K pullup to
5V See "Coolant Temperature" Setup
Wizard f or selection.