Class1 119327 - VDR system 118093 118097 118551 118620 119375 - EXTERNAL - Manual (Page 8)

FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-290 or 1-800-520-3473
PRODUCT MANUAL
PAGE 7 OF 26
DATE 10/17/2011
PRODUCT GROUP ES-Key P/N 119914, 118093, 118620, 118551, 119375 REV 1.70
PRODUCT Vehicle Data Recorder and Seat Belt Warning system BY AMS
Tight error validation: The seat position will remain in an error condition (red) even when the seat switch is
reactivated. This error validation reduces the risks associated with occupants attempting
to subvert the system by connecting the belt behind their bodies.
Loose error validation: The seat position will return to a valid seat/belt indication (green) when the seat switch is
reactivated. This error validation allows the occupant to lean in the seat (seat switch
deactivated) for longer than the “seat bounce” timing without maintaining an error condition
when the seat switch is reactivated.
Seat and belt tie error validation
The system will set an error condition (red) when the seat and belt switches are activated at the same time.
Tight error validation: The system will set an error condition (red) when the seat and belt switches are activated
at the same time. This error validation reduces the risks associated with occupants
attempting to subvert the system by connecting the belt behind their bodies prior to the
system power being applied (applicable only when the system is not continuously
powered).
Loose error validation: The system will set a valid seat/belt indication (green) when the seat and belt switches are
activated at the same time. This error validation allows an occupant to be seated and
belted properly prior to the driver applying vehicle power while still maintaining a valid
indication.
4.2.4. Address configuration
The Seat Belt Warning input module can be set to address 1 (default) or address 2. This allows two Seat Belt
Warning input modules to be used in applications where up to 20 seat/belt positions are required. Place the
address configuration jumper into the desired position (1 or 2).
 The Seat Belt Warning display (small – p/n 118620) can display the seat status from two Seat Belt Warning
input modules (up to twenty seats).
 Two Seat Belt Warning displays (large – p/n 118551) must be used to display the seat status from two Seat Belt
Warning input modules (up to twenty seats).