Select Increments Sky-Pod - Manual (Page 2)

2
1) The windshield’s hollow. You could get really tricky and drill out a hole in the windshield beneath the Sky-Pod so the wires
pop out and go right in the bottom of the pod. You would need to fish them down internally to the wiper motor, drill an exit
hole near the motor and then feed the wires through the hole for the wiper motor wires and then down behind the dash or to
your amplifier. Of course, you’d have to remove the side roll cage bars from the windshield to do so. This is a difficult way
and is not recommended.
2) (BEST WAY) You can attach the adhesive-back wire clips to the metal windshield frame and run the wires over to your roll
bar, then run them inside the padding and down to the floor, under the carpet and up to your amplifier or radio.
3) If you’re really handy, you may be able to use a shim of some kind and push the wires under your windshield gasket, though
it may take some time and be fairly frustrating.
‘03-’06 Wranglers:
Your Sky-Pod attaches to the windshield frame by removing the center plastic piece
of the Head Impact Plastic and removing the updated footman loop. First, you’ll want to remove the center plastic piece:
You’ll have to remove this first
It is held on by metal ‘pop’ clips and easily removes by moving the visors off to the sides, releasing the vehicle’s top clamps and
pulling on the plastic piece at one side and slowly working your way over to the other side For a really tidy appearance, you can
actually cut the Head Impact Plastic piece so it fits around the Sky-Pod. When doing so, you only lose one clip, so it will still
stay in place when re-installed.
When cutting you will lose this clip only
After your cut, the piece will look something like this.
It can then be re-installed before installing the Sky-Pod for a real factory look. You’ll push on the edge trim piece that’s included with
your pod to hide your cut. Some accurate measurements will ensure a tidy appearance and/or cut out the template below and use it as
a guide for cutting the hole out. This is the recommended installation method regarding the Head Impact Plastic piece.
TOP – towards foot man loop
BOTTOM – towards glass
Cut this along the dotted line and center on plastic piece. It will roll
right over the top and stop at the edge. Mark it and cut out the
plasticwith snips, roto-zip tool, etc. just take your time. It doesn’t have
to be a perfect cut because the push-on rubber edge trim will hide it and
make a nice factory appearance.