Behringer EP 1500 - Manual (Page 10)

10
EUROPOWER EP1500/EP2500
4. INSTALLATION
4.1.1 Using the binding posts
To connect the loudspeakers to the amplifier’s binding posts,
please do the following:
1.
Switch off the amp and disconnect it from the mains (unplug
mains connector).
2. Remove the protective plastic covers shielding the binding
posts by loosening the two screws on the right-hand side
of the connections and lift the plastic cover upwards.
3. Attach the terminal of your loudspeaker cable to the corres-
ponding binding post.
4. Place the protective plastic covers into its original upright
position on each binding post and replace the two screws.
Never operate the device without the protective plastic
covers in place!
Fig 4.2: Protective plastic covers shielding the binding posts
When using binding post connectors, please make sure that
insulation on cables is not removed too high. Insert the naked
part of the cable fully so that no metal is visible. Cable clamps
must be isolated to avoid the possibility of electric shock. When
running the amp in mono-bridged mode, always use the middle
two binding post connectors, paying attention to correct polarity.
+
ATTENTION! If you notice naked cable endings on
the binding post connectors, do not power up the
amp because of the risk of electric shock.
4.1.2 Connecting to the mains
Always connect your EUROPOWER amplifier to the voltage
specified on the rear of the device. Connecting the amp to an
incorrect voltage can permanently damage your amp.
Before powering up the amplifier, double-check all
connections and fully lower the gain setting.
4.2 Audio connections
Various cables are needed for different types of applications.
The following illustrations show the correct wiring. Always use
high-grade cables.
+
When connecting a balanced input signal, please
make sure to exclusively use balanced cables for
passing the signal further on. Otherwise, one
single unbalanced cable can turn the entire signal
unbalanced.
Fig. 4.2: XLR connections
Fig. 4.3: 1/4" TS connector
Fig. 4.4: 1/4" TRS connector