Black & Decker HX280 - Manual (Page 4)

Features
• 2000W
• 2-Heat settings
• Fan
• Cord storage
How to use your Fan Heater
Caution: This product is intended for heating rooms. Do not use this appliance for any other purpose.
For indoor, domestic use only.
Heater Operation:
• Fully unwind the cord & place the unit on a flat, even floor away from any obstructions and pointing towards
the area of the room to be heated.
• Rotate the heating selector (3) to setting l or ll as required, and rotate the thermostat dial (1) to maximum.
• Connect the appliance to a suitable electrical supply.
• The “power” lamp (2) will illuminate and warm air will be blown into the room.
• When the temperature of the room is at the desired level, rotate the thermostat dial (1) slowly in an
anticlockwise direction until the appliance just stops working. The “power” lamp (2) will go out. The
temperature will be maintained at the present level by the thermostat inside the unit.
• During this time, the “power” lamp (2) will cycle on and off with the Heater.
• When it is no longer necessary to heat the room, rotate the heating selector (3) to setting “0” to switch the
unit off and unplug it from the mains supply.
Note: This appliance must be attended in use.
Always use the product in an upright position, on a flat, level surface.
Warning: In order to avoid overheating, do not cover this appliance.
-4-
Denotes Do not cover
HX175
Cord storage (5)
HX280
Cord storage (5)