Butler PIG DESIGN 92647 User Manual
Page 3
SKU 92647 For technical questions, please call 1-800-444-3353
12. THIS PRODUCT IS MANUFACTURED OF CAST IRON. Do not force any part of the assembly
and do not overtighten the bolts. Serious damage can occur. Do not stand on this Bench. Use
only for intended purpose. The Park Bench is made for children. Children need to be supervised.
Injury could occur if Park Bench is overloaded. Use caution!
13. STORE IDLE EQUIPMENT. When not in use, products must be stored in a dry location to inhibit
damage from moisture and salt air.
14. TIPPING HAZARD. Do not jump or climb on the Bench. Do not allow anyone to sit on the back
of the Bench.
15. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical replacement
parts. Use of any other parts will void the warranty.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by the operator
that common sense and caution are factors which cannot be built into this product, but must be
supplied by the operator.
UNPACKING
When unpacking, check to make sure all parts shown on the Parts List (page 5) are
included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
We suggest you assemble the unit on a soft surface to avoid damage to the finish.
1.
PLACING SLATS: Attach the five Seat Slats (3) in the channel of the End Pieces (2)
as shown. Note: The Round Slat is to be anchored in the front of the Bench. Use the
Bolts, Washers, and Nuts (4) to attach.
See Figure 1.
Note: It may become necessary to enlarge the holes in the End Pieces (2). Clear
the hole of paint by sliding a bolt through the hole or using a drill before assembly.
ASSEMBLY OF BENCH
Figure 1
Page 3
Round Back
Assembly (1)
Bolts (4)
End Piece-Right
Side (2-R)
Seat Slats (3)
Round Slat
in Front