Apple Multiple Scan 720 Display User Manual
Page 7
Setting Up
7
Connecting the Apple Multiple Scan Display
to your computer
Important
Before you connect any cords or cables, make sure that your computer is
turned off and unplugged.
1
Connect the socket end of the monitor power cord to the power cord receptacle on the back
of the display.
2
Plug the other end of the monitor power cord into the power socket on your computer.
3
If you are connecting the monitor to a Mac OS–based computer, insert the monitor
connector into the monitor port (marked with
™) on the back of the computer and tighten
the thumbscrews.
4
If you are connecting the monitor to an IBM PC-compatible computer, connect the adapter
that you acquired from your dealer to the monitor connector on the monitor cable, and
tighten the thumbscrews. Then insert the monitor connector with the adapter into the
monitor port on your computer.
If you installed a graphics card in your computer, connect the monitor cable to the graphics
card’s port instead. For information about installing graphics cards, see the manual that came
with your computer or graphics card.
PC adapter
Connector on
monitor cable
Monitor port on
IBM PC-compatible
computer
Monitor port icon
Connector on
monitor cable