Operation, Introduction, Before starting & operating – MBW GP3000-15 User Manual
Page 8: Starting engine, Operating, Stopping engine, Peration
- 5 -
O
PERATION
Introduction
MBW equipment is intended for use in very severe
applications. They are powered by four cycle engines and
are available in different sizes and a selection of engines.
This parts manual contains only standard parts. Variations
of these parts as well as other special parts are not included.
Contact your local MBW distributor for assistance in
identifying parts not included in this manual.
Before Starting & Operating
• REMEMBER! It is the owner’s responsibility to
communicate information on the safe use and proper
operation of this unit to the operators.
• Review ALL of the Safety Precautions listed on page 1 of
this manual.
• Familiarize yourself with the operation of the machine
and confirm that all controls function properly.
• Know how to STOP the machine in case of an
emergency.
• Make sure hands, feet, and clothing are at a safe
distance from any moving parts.
• OIL LEVEL - Check the oil level in the engine. For more
information see “Lubrication” under the respective
engine’s “Owners Manual” or the Maintenance section
of this manual.
• AIR CLEANER - Check to ensure element is in good
condition and properly installed.
• FUEL SUPPLY - The engines on MBW equipment
require an automotive grade of clean, fresh, unleaded
gasoline.
• FUEL FILTER - If clogged or damaged, replace.
Starting Engine
1.
Open fuel valve.
2.
Turn engine switch to “ON”.
3.
Set throttle to idle.
4.
Choke engine if necessary (you may not need to
choke a warm engine).
5.
Pull starter rope repeatedly until engine starts.
6.
Move choke lever to open position.
7.
Allow engine to warm up for one or two minutes.
Operating
1.
Open throttle fully.
2.
Compactor will begin vibrating and moving in a
forward direction.
3.
Maximum compaction of soil has been reached when
excessive kickback is noticed in the compactor. The
number of passes needed to reach compaction level
desired will depend on soil type and moisture.
4.
When using the compactor on asphalt use the water
sprinkling system to keep the plate bottom from
adhering to the hot asphalt.
Stopping Engine
1.
Move throttle to idle position.
2.
Let engine idle for one or two minutes.
3.
Turn switch on engine to “STOP” position.
4.
Turn off fuel valve.
WARNING
Always stop the engine before:
Adding fuel.
Leaving the equipment unattended for any
amount of time.
Before making any repairs or adjustments to the
machine.