MBW EXA30 - Manual (Page 9)

- 6 -
4. Remove the old shock mounts by pressing them out.
A small hydraulic jack works best. 5. Lubricate the new mount and inner surface of frame.
Be sure to completely cover both surfaces.
Note: Lubricate with a liquid soap or rubber lubricant.
Use of grease or oil may damage the rubber.
6. Assemble the components of the tool, shock mount,
and EXA frame as shown in figure 1.
7. Tighten the nut against the shockmount until it is fully
seated against the step on the back plate.
5$',86
67(3
Fig 1.