MBW VS77M - Manual (Page 6)

- 3 -
O
PERATION
Introduction
MBW equipment is intended for use in very severe
applications. The Vibration Suppressor is available in a
variety of configurations.
This parts manual contains only standard parts. Variations
of these parts as well as other special parts are not included.
Contact your local MBW distributor for assistance in
identifying parts not included in this manual.
Installation
• The MBW Vibration suppressor is intended to be
installed on a variety of pneumatic pole tampers.
• Connection adapters are included with some models to
add flexibility to installation
1. Disconnect air supply to tool and make sure all air
pressure is released
2. Unscrew connector pipe between trigger assembly
and main percussion unit
3. Attach “ROD” end of the Vibration Suppressor to the
main percussion unit. Tighten connection using a
supplied lock-nut
4. Attach trigger assembly to other end of the Vibration
Suppressor. Tighten connection using a supplied
lock-nut
• Depending on Pole Tamper style, adapters may be
needed to make connections
• To ensure connections stay tight, MBW recommends
using a medium strength thread locker on all
connections
• To lengthen the pole tamper assembly, it is
recommended that the added pipe section be placed
above the Vibration Suppressor
Before Starting & Operating
• REMEMBER! It is the owner’s responsibility to
communicate information on the safe use and proper
operation of this unit to the operators.
• Review ALL of the Safety Precautions listed on page 1 of
this manual.
• Familiarize yourself with the operation of the machine
and confirm that all controls function properly.
• Know how to STOP the machine in case of an
emergency.
75,**(5
$66(0%/<
(;7(16,21
3,3(
$'$37(5
9,%5$7,21
68335(6625
3(5&866,21
81,7