Lull 644B Parts Manual - Manual (Page 12)

9
The next page (2.40.1.1) shows that it contains the information for your machine
model and serial number (Figure 3, H & I). The gray arrow (J) means that’s the
last page for that particular subject.
Page Numbers
Understanding how the page numbers are structured will help you navigate
through the book.
Figure 4
Figure 4 shows a typical page number.
• First number (K): Always matches the section number.
• Second number (L): Represents the subject title (N) in that section only.
• Third number (M): Shows page order for the machine models under that
particular subject (N).
Figure 5
Figure 5 shows a page number with additional serial numbers not covered by the
previous page (Figure 4).
• Fourth number (O): First, second, third, etc., page of additional serial
numbers for the specified models.
L
K M
N
O
General Information
The revision appears in the right hand margin of each page.The quantity shown
in the “QTY” column is the number of parts used on that assembly. Where parts
are referenced “REF” the part shown is included in another assembly or part of
another item. For certain parts such as shims, spacers, etc. “A/R” indicates that
the quantity to be used is as required.
Abbreviations
The following abbreviations are commonly used in this manual:
A/R ........................................ As Required
Amp .............................................. Ampere
Ass’y .......................................... Assembly
AUX ............................................. Auxiliary
BCI ...............Battery Council International
C............................................(Metric) Class
CCA ... Cold Cranking Performance Rating
Cyl. ...............................................Cylinder
D.P.D.T. ................. Dual Pole, Dual Throw
D.P.S.T. .............. Dual Pole, Single Throw
Dia. ............................................. Diameter
Diff. ...........................................Differential
GA .................................................. Gauge
GR ................................................... Grade
Hd. .................................................... Head
Hx. .......................................................Hex
Hyd. ............................................ Hydraulic
I.D. ....................................Inside Diameter
in. ................................................... Inches
Incl. ...............................................Includes
JIC ...........................Joint Industry Council
Lg. ..................................................... Long
L.H. ............................................ Left Hand
mm .............................................Millimeter N/A ................................. Not Applicable
N.L.A. .................... No Longer Available
N.P.T. ...................National Pipe Thread
N.S.S. ................... Not Sold Separately
O.D. .......................... Outside Diameter
Osc. ...................................... Oscillation
oz. ...........................................Ounce(s)
Pcs. .............................................Pieces
P/N .................................... Part Number
P.S.I. .............. Pounds Per Square Inch
Pt. ................................................. Point
Rd. ..............................................Round
REF ...................................... Reference
Req. ........................................Required
R.H. .................................... Right Hand
S.P.D.T. ........... Single Pole, Dual Throw
S.P.S.T. ........ Single Pole, Single Throw
S/N ................................. Serial Number
SAE .. Society of Automotive Engineers
STD. .......................................Standard
Temp. ................................ Temperature
Trans. ............................... Transmission
w/ ................................................... With
w/o ............................................ Without
Rev. 002