CompuSTAR 2WAM (LCD) (Remote 2WAMR) - Manual (Page 7)

Page 12 Page 13
While the vehicle is in valet mode, only the keyless entry function will be available.
Valet Mode is very useful when loaning your vehicle or having it serviced.
In order to enter Valet mode, press buttons ( I + I I I ) simultaneously for a 1/2 second.
In order to manually enter Valet Mode, insert your key into the ignition and turn
the ignition on, then off,
(between ACC and ON) five times within 10 seconds.
Valet Mode
You can exit Valet Mode only by pressing buttons
( I + I I I ) simultaneously for a 1/2 second.
Safety Shut Down Features
The CompuStar 2WAMR system has several shut down safety features.
The following actions will shut down the engine or prevent the car from auto-starting :
Opening the hood, pressing the brake, or if Valet Mode is turned on.
Turbo Mode
If this optional Turbo Mode has been programmed at the time of installation,
you can turn this feature on and off by pressing buttons ( I I I + I V ) for a 1/2 second.
In this mode, if the emergency brake has been set, the engine will continue to run
after the key has been taken out of the ignition. It will run until two minutes after the
emergency brake has been set.
• To utilize this mode, the emergency brake sensing wire has to be connected to the
emergency brake wire of the vehicle. Consult the authorized dealer for this mode.
• This option is ideal for turbo-charged vehicles because it allows the turbo too
slowly cool after operation.