Road Armor 2009-2012 Ford F-150 Front Bumper User Manual
Road Armor For the car
2009 - 2011 Ford F150
Front Bumper
Warning!
Read the instructions completely before beginning the installation. Before tightening bolts, drilling
or cutting where required, check to make sure that there are no obstructions such as brake, fuel
or electrical lines that may be damaged. Also keep in mind this is an aftermarket product and MAY
require some minor shimming and or trimming, reaming etc. to fi t properly.
IMPORTANT NOTICE
IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED...
-BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE
SURFACE PREPARATION BEFORE HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.
-ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS
WITH FIT OR FINISH ARE NOT NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.
THANK YOU
TOOLS NEEDED
-Socket set, Ratchet & Wrenches (metric & standard)-
-Road Armor thanks you for supporting the American Economy!-
- Common Sense Tape Measure and a bit of Patience-
-Hand Grinder with Cutoff Wheel-
-Power Drill and 1/2” bit-
SUGGESTED LIGHTS THAT FIT THIS UNIT:
PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).
Warn 350F - www.warn.com Part Number (82410).