Road Armor 2009-2012 Ford F-150 Rear Bumper - Manual

2009 - 2012 FORD F150
REAR BUMPER
INSTALL INSTRUCTIONS
Warning!
Read the instructions completely before beginning the installation. Before tightening bolts, drilling
or cutting where required, check to make sure that there are no obstructions such as brake, fuel
or electrical lines that may be damaged. Also keep in mind this is an aftermarket product and MAY
require some minor shimming and or trimming, reaming etc. to fit properly.
IMPORTANT NOTICE
IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED...
-BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE
SURFACE PREPARATION BEFORE HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.
-ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS
WITH FIT OR FINISH ARE NOT NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.
THANK YOU
TOOLS NEEDED
-Yourself and a strong friend / bumper jack.
( Don’t worry, we’re not calling you or your friend a “tool” )
- Socket set, Ratchet & Wrenches (metric & standard)
( ... more than likely metric for your rig, cause everything’s imported these days,
and standard for your new bad ass Made in USA bumper.
Road Armor thanks you for supporting the American Economy! )
- Common Sense Tape Measure and a bit of Patience
( And also a cold drink to celebrate afterwards )
SUGGESTED LIGHTS THAT FIT THIS UNIT:
PIAA 2000 - www.piaa.com - Part Numbers (2091, 2090).
Hella 1400 Optilux