Road Armor 2014 Chevy 1500 Rear Bumper - Manual (Page 6)

Installation of the Rear bumper
Step 1 Install RA bumper brackets loosely with 1.5” bolts and hardware in place of factory hitch bolt.
Step 1
Now on to installing your Road Armor bumper
Verify you have all the hardware that was sent with the Bumper. The Rear Bumper requires the following hard-
ware.
(6) Single Bolt Plates
(2) 1/2” Push On Retainers
(10) 1/2” Flat Washers
(8) 1/2” Lock Washers
(8)) 1/2” - 13 Hex Nuts
(2) Small logo kit
(4) 1” Plastic plugs
(1) Receiver plug plate
(2) 1.5” X .5 bolt
There are several steps you need to take before installing your new Road Armor bumpers.
1. unplug the Sensors
2. Remove 2 bolts in the center of the bumper
3. Remove the Trailer Hitch plug
4. Remove the Receiver
5. Lower the spare tire if installing a winch
6. Unbolt the bumper brackets
7. The bumper brackets will interfere with the bed. You can either pry it past or loosen the bed bolts and remove factory
RA bracket
Factory bolt
1.5” bolt