Road Armor 2015 Chevy 2500 Rear Bumper - Manual (Page 2)

Installation of the Rear bumper
Step 1
Now on to installing your Road Armor bumper. This should have a part number for 312.
Verify you have all the hardware that was sent with the Bumper. The Rear Bumper requires the following hard-
ware.
(12) Single Bolt Plates
(2) 1/2” Push On Retainers
(12) 1/2” Flat Washers
(12) 1/2” Lock Washers
(12) 1/2” - 13 Hex Nuts
(2) logo kits
(4) 1” Plastic plugs
(1) Receiver plug plate
(1) Small logo
There are several steps you need to take before installing your new Road Armor bumpers.
1. unplug the Sensors
2. Remove 2 bolts in the center of the bumper
3. Remove the Trailer Hitch plug
4. Unbolt the bumper brackets
5. The bumper brackets will interfere with the bed. Loosen the bed bolts and remove factory bumper then tighten
Step 1 Install RA bumper brackets loosely with supplied hardware.