Ruvati RVF1251RB - Manual (Page 5)

Hot & Cold Water Supply Hoses
®
RVF1251RB
www.ruvati.com Printed in USA
1-855-4-RUVATI
Page 4
Installation
®
4. Screw the locknut all the way up
the threaded shank of the faucet un-
til tight. Then using a Phillips- Head
Screwdriver, tighten the screws of
the locknut until tight (Figure 3).
3. From underneath the deck/sink,
slide the rubber washer followed by
the metal washer all the way up the
threaded shank of the faucet (Figure
3).
2. Place the faucet body into the
faucet hole of the deck/sink (Figure
2). A standard 1-3/8” hole is required
for this faucet.
Figure 3
Figure 2
Figure 1
1. Remove rubber washer, metal
washer, and locknut from the threaded
shank (Figure 1). If you look closely,
you will find a black rubber O ring
sitting in a groove on the underside of
the base of the faucet, just above the
threaded shank. Do not remove this O
ring (Figure 1).