Ruvati RVF1221BN - Manual (Page 5)

®
Hot & Cold Water Supply Hoses
®
RVF1221BN
www.ruvati.com Printed in USA
1-855-4-RUVATI
Page 4
Installation
®
1. Remove rubber washer, metal
washer, and locknut from the thread-
ed shank (Figure 1).
4. Screw the locknut all the way up
the threaded shank of the faucet un-
til tight. Then using a Phillips- Head
Screwdriver, tighten the screws of
the locknut until tight (Figure 3).
3. From underneath the deck/sink,
slide the rubber washer followed by
the metal washer all the way up the
threaed shank of the faucet (Figure
3).
2. Place the faucet body into the
faucet hole of the deck/sink (Figure
2). A standard 1-3/8” hole is required
for this faucet.
Figure 3
Figure 2
Figure 1