Lukas SC 357 E2 - Manual (Page 6)

6
Immediately report any
changes that occur (including
changes in operating
behavior) to the appropriate
persons/departments! If
necessary, the equipment is
to be shut down immediately
and secured! All bolted connections must
be checked for leaks and
externally visible damage,
which must be repaired
immediately! Escaping
hydraulic fl uid can cause
injuries and fi res.
In the event of malfunction,
immediately deactivate the
device and secure it. Repair
the fault immediately. Do not carry out any changes
(additions or conversions)
to the equipment without
obtaining the prior approval of
LUKAS.
Observe all safety and danger
information on the device and
in the operating instructions. All safety and danger
instructions on the device
must always be complete and
in a legible condition.
Any mode of operation which
compromises the safety and/
or stability of the device is
forbidden! Repairs to the equipment
may only be carried out by
a trained service technician
with specifi c knowledge of the
device.
Safety devices may never be
disabled! Only genuine LUKAS
accessories and spare parts
are to be used for repairs.
Before switching on/starting
up the device and during its
operation, make sure that
nobody will be endangered
by this. Observe all intervals
for recurring tests and/
or inspections that are
prescribed or stated in the
operating instructions.
When working close to live
components and cables,
suitable measures must
be taken to avoid current
transfers or high-voltage
transfers to the equipment. Please note that material
could fall down or suddenly
break free during spreading,
cutting, squeezing operations
as a result of shearing,
tearing or breaking;
appropriate steps must be
taken to avoid this.