Lukas HTS 90 User Manual
Page 3
3.2
Before starting up or setting the machine in motion and during operation of the machine
make sure that nobody is at risk.
3.3
Before transporting the machine always check that the accessories have been safely
stowed away.
3.4
Make sure that there is enough lighting during work.
3.5
Avoid any operation that might be a risk to machine stability.
3.6
Check the machine at least after every operation for obvious damage and defects.
Report any changes (incl. changes in the machines working behaviour) to the competent
organization /person immediately. If necessary, stop the machine immediately and lock it. All
lines, hoses and screwed connections have to be checked for leaks and obvious damage.
Repair damage immediately. Splashed oil may cause injury and fire.
3.7
All safety equipment has to be checked for completeness and flawless condition:
- instruction markings and warning signs (safety instructions)
- check safety cover (e.g. motor-safety covers, heat protection etc.) if they are available and
if they are in good condition.
3.8
Working under loads is not allowed if they are only lifted by hydraulic cylinders. If the
work is indispensable sufficient mechanical supports are needed additionally.
3.9
Do not stress hoses mechanically (pulling, buckling etc.).
4
Instructions for maintenance and service
4.1
For the execution of maintenance and service work, tools and workshop equipment
adapted to the task on hand are absolutely indispensable.
Work on the hydraulic system must be carried out only by personnel having special
knowledge and experience with hydraulic equipment.
4.2
Before putting into operation clean the machine, especially connections and threaded
unions, of any traces of oil, fuel or preservatives before carrying out maintenance/repair.
Never use aggressive detergents. Use lint-free cleaning rags and pay attention that the
components are meticulously clean during reassembling after repair.
4.3
During dismantling of machines it is necessary to collect the outrunning hydraulic liquids
completely, so that they cannot reach the ground. They have to be disposed properly accord-
ing to the instructions.
4.4
Always tighten any screwed and thread connections that have been loosened during
maintenance and repair. Observe the stipulated torques.
4.5
Work on the electrical system or equipment may only be carried out by a skilled
electrician himself or by specially instructed personnel under the control and supervision of
such electri- cian and in accordance with the applicable electrical engineering rules.
4.6
The electrical equipment of machines is to be inspected and checked at regular intervals.
Defects such as loose connections or scorched cables must be rectified immediately.
4.7
Aggressive material (acid, lye, solvent, vapour) can damage the machine. It is necessary
to clean the whole machine if it must be exceptionally operated under such conditions or gets
into touch with these materials. Additionally, the machine must be checked as described
under 3.6.