Lukas Telescopic Rams - Manual (Page 4)

4
2.6 Spare parts must comply with the technical requirements specified by the manufacturer. Spare
parts from original equipment manufacturers can be relied to do so. It is only allowed to use
original LUKAS spare parts or LUKAS system components.
2.7 Replace hydraulic hoses within stipulated and appropriate intervals even if no safety-relevant
defects have been detected. This has to be done after 10 years at the latest.
2.8 Adhere to prescribed intervals or those specified in the operating instructions for routine checks
and inspections.
2.9 Make sure to dispose properly of packing material and dismounted parts!
3 General safety instructions
3.1 Check all parts for possible damage before starting up.
3.2 When operating the machine, pay attention to the ambient conditions, making sure that you
wear suitable personal protective clothing. Also pay attention to the fact that the cylinders could heat
up after a while. They may also cool down considerably depending on the ambient conditions. This
must likewise be borne in mind by wearing suitable protective clothing.
3.3 Also be aware that possible noise could result from various sources during operation which may
impede communication.
During operation, there may also be impairment from exhaust fumes. Make sure that there is sufficient
ventilation or that protective measures are taken.
Since the cylinders are coupled with hose pipes, they may constitute a tripping risk. Ensure that the
hose pipes are safely installed. This is especially important due to the fact that escape routes must
be provided.
3.4 When working, make sure there is sufficient lighting and a clear view of the machine, so as to
guarantee safe working conditions.
3.5 Before switching on/starting up and while operating the machine, please ensure that nobody
will be endangered when the machine starts running. Also, secure the machine against unauthorised
or accidental switching on/off.
3.6 In the event of malfunctions, stop the machine immediately and lock it. Have any defects
rectified immediately.
3.7 Before setting the machine in motion always check that the accessories have been safely
stowed away! During transport, the weight of the LUKAS telescopic cylinders must be taken into
account.
3.8 Avoid any operation that might be a risk to machine stability! For this reason, a base plate (refer
to chapter 9.1) must be used. Also check that the foundation has sufficient load-bearing capacity.
3.9 Check the machine at least after every operation for obvious damage and defects. Report any
changes (incl. changes in the machine’s working behaviour) to the competent organization/person
immediately. If necessary, stop the machine immediately and lock it. All lines, hoses and screwed
connections have to be checked for leaks and obvious damage. Repair damage immediately.
Splashed oil may cause injury and fire.
3.10 All safety equipments have to be checked for completeness and flawless condition:
- instruction markings and warning signs (safety instructions)
- check safety cover (e.g. motor-safety covers, heat protection etc.) if they are available and if they
are in a good condition.