Beam Electrolux Alliance V.2 - Manual (Page 6)

6
Before hanging the power unit on the wall ensure the intake
fl ange on the power unit is positioned in the correct direction
(see section 1.4); muffler is installed correctly (see section
1.5), optional HEPA fi lter is installed correctly (see section
1.6); and optional bag adaptor is installed correctly (see
section 1.8).
Strip the low-voltage wires that were installed with the
main trunk line. Connect the wires to the spring-loaded
connectors on the back of the power unit (refer to Figure 3).
Hang the power unit on the bracket. Connect the main tube
line to the intake fl ange of the vacuum with the connector
and clamp provided.
DO NOT glue the main tube line to the power unit so that
the power unit may be removed for future maintenance or
service.
WARNING
• WARNING: Do not block the exhaust pipe. Lack of ventilation will cause the motor to
overheat.
• WARNING: Do not locate the power unit in a high temperature area where it is
inaccessible for example, an attic or crawl space.
1.4 Intake Flange
Your power unit has been designed for either a left or right pipe intake. If the pipe from your house is
located on the right side of the power unit, you will need to change the direction of the intake fl ange.
To do this, remove the two Torx 20 screws located on the intake fl ange and turn the intake fl ange 180°.
Secure the intake fl ange with the same two Torx 20 screws previously removed (refer to Figure 4).
Figure 3
Figure 4