Mountain Off Road BBTJ0006 - Manual

MOUNTAIN OFF ROAD ENTERPRISES, LLC.
P.O. BOX 690 DELTA COLORADO 81416
970-625-0500
970-625-3747 FAX
E-mail: [email protected]
www.mountainoffroad.com
INSTALLATION INSTRUCTIONS for BBTJ0006 BombProof™ BLOCK BRACKETS
Please read and understand all instructions before beginning the installation of these motor mounts. Please read
the terms and policies on the back of these instructions.
The BBTJ0006 Block Brackets are designed to fit the following Jeep® vehicles: 2000-2006 TJ, LJ Wranglers
equipped with 6-cylinder engines (4.0L ). These Brackets will work with the OEM motor mounts along with most
Aftermarket Motor Mounts.
STEP 1: With the Jeep® on flat level ground, apply the parking brake, block the tires so it cannot move.
Put the transmission in neutral. Using a jack, place a block of wood between the jack and the oil pan. Apply a
slight amount of pressure on the oil pan. We recommend doing one side at a time.
STEP 2: On the drivers side remove the through bolt, lower nut and bolt on the motor mount and then
remove the motor mount. Save this hardware! remove the OEM block bracket and the bracket that attaches to
the block and to the AC compressor ( see figure 3 ). The new Block Bracket will reattach to the block using the
original three holes plus five additional threaded holes on the block. We recommend cleaning the new holes with
a 3/8”x16 tap. ( see figure 1)
STEP 3: Install the new DS Block Bracket and motor mount together, attach the block bracket using the
supplied hardware using loc-tite on the bolts , ( See Figure 2 for bolt locations ). On the hole where the AC bracket
you removed in step 2 was, is where you will install the new supplied bracket, this bracket goes behind the block bracket ( see
figure 4 ).
Do not tighten the bolts yet. Reinstall the original motor mount bolts and nuts and check to see if the
motor mount is in the same location as before, if not the block bracket can be moved slightly to realign the mount
to the frame bracket. After the alignment is correct tighten the block bracket bolts and the bolt and nut on the mo-
tor mount. Do not Tighten the through bolt on the motor mount at this time.
STEP 4: On the Passenger side Remove the through bolt, lower nut and bolt on the motor mount and
then remove the motor mount. Save this hardware! remove the OEM block bracket. The new Block Bracket will
reattach to the block using the original three holes plus five additional threaded holes on the block. We recom-
mend cleaning the new holes with a 3/8”x16 tap and the. ( see figure 3 )
Page 1
HARDWARE KIT:
1– DS Block Bracket
1– PS Block Bracket
11– 3/8-16x1 Bolt
4– 3/8-16x1-1/4 Bolt
1– 3/8-16x1-1/2 Bolt
16– 3/8” Flat Washers
16– 3/8” Lock Washers
1– AC Bracket