Mountain Off Road JRB801 - Manual (Page 2)

PAGE 2 of 3
M.O.R.E.™ recommends pre-fitting this BUMPER into your Jeep® BEFORE you
paint it. Make sure that you Have no fit issues with any Aftermarket accessories
and that you are happy with all aspects of it. If you are, then paint it and re-install it.
Once you modify it in any way, it is NON-RETURNABLE !!!
1– Remove Factory rear bumper & if equipped remove tow hitch and or tow hook.
Save the 4 factory bolts that attached the bumper to the frame on the sides of the
frame (see figure 1B) .
2– The JRB800 bumper will attach to the back crossmember with 4 bolts (see fig-
ures 1A & 1B) and to the 4 bolts removed earlier from the sides of the frame.
3– Install JRB800 rear bumper and install the 4 factory bolts back into the side
frame holes do not tighten at this time ( See Figure 2) . Install the 7/16x4.5”
bolts ,flat and lock washers through the backing plate and then through the rear
crossmember of the Jeep (see figure 3). NOTE: It may be necessary to enlarge the
outside of the holes on the rear crossmemeber (see figure 4).Tighten the 4 7/16”
bolts in the center and then the 4 bolts on the sides of the frame.
Figure 1A Figure 1B
4– 7/16”x 4.5” bolts coming in from the back 2– Factory bolts per side of frame.