Mountain Off Road JRB901TJ - Manual (Page 2)

PAGE 2 of 3
M.O.R.E.™ recommends pre-fitting this BUMPER into your Jeep® BEFORE you paint it. Make
sure that you Have no fit issues with any Aftermarket accessories and that you are happy with all
aspects of it. If you are, then paint it and re-install it. Once you modify it in any way, it is NON-
RETURNABLE !!!
1– Remove Factory rear bumper & if equipped remove tow hitch. Save the 2 lower factory bolts
that attached the bumper to the frame. ( Figure 1) .
2– The JRB901 bumper will attach to the back crossmember with 4 bolts per side, Some Jeeps
already have these holes but many do not. You will have to mark and drill these holes to 1/2”.
( Be careful when drilling so you do not hit the fuel tank). ( Figure 2 & 2A)
3– Install JRB901 rear bumper and install the 2 factory bolts back into the lower frame holes .
Finger tighten these bolts at this time. ( Figure 1)
4– Install Left & Right Frame brackets Using the 7/16”x1 1/4” bolts, flat washers, lock washers
and Tab nuts. ( Figure 3 & 4). Nut tab will insert in hole in bottom of the frame. Do not tighten at
this time.
5– Insert the 7/16”-1 1/2” bolts w/ flat washer through the Frame bracket, frame and bumper and
attach with flat washer and 7/16” crimp nut. ( Figure 5)
6– Insert the 7/16”-1 1/2” bolts w/ flat washer through the Backing plates, frame ( holes that may
of had to be drilled) and bumper and attach with flat washer and 7/16” crimp nut. ( Figure 6)
7– Center & Level bumper and tighten all bolts.
Figure 1, ( P.S. of Jeep)
Figure 2