Mountain Off Road 7686-FWK2.0 - Manual (Page 3)

7686-FWK2.0 S.R.S.™ - GENERAL INFORMATION:
This system will fit Jeep® CJ vehicles with any engine. This system will lift the front of the
Jeep® (1”-1.5”) over where it sits now. Before starting this installation, check the frame to
make sure it is in good condition, is straight and has no excessive rust. Only install it on vehi-
cles in good sound condition. This system will work with stock and most aftermarket bump-
ers, with or without a winch. Welding, cutting and grinding is required for installation.
AXLES:
This kit is designed to work with Full Width Axles that have spring perches t hat measure
31-1/4” to 31-1/2” Center to Center.
FITTING CONCERNS:
Interference with nerf bars & headers may become an issue. Please check
on these issues before continuing.
LEAF SPRINGS:
This system has been designed to work with 2.0” CJ stock and aftermarket leaf
springs. It has been tested with several different manufactures springs up to 4.5” lift and works fine. It
will work with springs that have been placed on top of the axle housing (spring over axle).
PITMAN ARM:
You may need to use a stock pitman arm. If a “dropped” arm is used there is a pos-
sibility that the tie rod could contact the drag link upon suspension compression. This will depend on
the amount of lift, be sure and check for any interference! M.O.R.E.™ offers a Heavy Duty steering
gear bracket that will move the steering box forward 1-1/4” , PN# SB7686-1.
DRIVE SHAFT:
The front drive shaft will need to be modified. A longer travel slip-yoke needs to be
installed. Due to the suspension movement the stock slip-yoke will not have enough travel and the
fact that this system will push the axle forward approx. one inch, the stock shaft length will not be
enough. M.O.R.E.™ recommends calling Tom Wood’s Custom Drive Shafts at: 877-497-4238.
BRAKE HOSES:
The stock brake hoses will work if you are using stock leaf springs mounted under
the axle. If you have any lift in your springs, or a spring over axle conversion, the stock hoses will
have to be replaced with longer ones. M.O.R.E.™ has Extended Stainless Braided Brake Lines avail-
able if needed.
TERMS-POLICIES:
DAMAGE CLAIMS: All orders are carefully packed, however, mishandling by the carrier can result in damage. The carrier has the responsibility for the shipment
from the time it leaves our warehouse until it is delivered to you. All claims for lost or damaged goods should be reported to the carrier, not to M.O.R.E.™ LLC.
RETURNS: No returns will be accepted without prior permission from M.O.R.E.™ LLC. After you receive a Return Goods Authorization (RGA) number, merchan-
dise must be returned prepaid and insured. A claim must be made with in 30 days from receipt of merchandise. The original invoice or a copy with the RGA
number written on must accompany all returns. A 20% restocking fee will be charged on all parts returned for credit or refund unless merchandise is proven to be
defective or was shipped wrong by M.O.R.E.™ LLC. No merchandise will be issued credit or refund if it has been installed, modified, used in any way or is in
unsalable condition.
WARRANTY: All merchandise is warranted to be free from defects in materials and workmanship prior to installation. Any alteration or improper use will void this
warranty. Because all parts we sell are intended for use in heavy-duty applications it is not possible to warrantee or guarantee the performance of any items.
M.O.R.E.™ LLC. products and the products manufactured by others, which we sell may be subject to an infinite variety of conditions due to the manner in which
they are used, serviced and/or installed. Purchasers and users of such products rely upon their own judgment as to the suitable use selection, service and instal-
lation of such products.
PRODUCT DISCLAIMER: Modification of your vehicle to enhance performance with parts sold by M.O.R.E.™ LLC. may create a dangerous condition which
could cause serious bodily injury, and the buyer hereby expressly assumes all risks associated with any such modifications. All parts sold by M.O.R.E.™ LLC.
and for racing or off road use only. Mountain Off Road Enterprises LLC. will not accept responsibility for personal injury or property damage arising from the
failure of any parts manufactured or sold by M.O.R.E.™ LLC.
Specifications are subject to change without notice.
Jeep®, AMC®, CJ®,YJ®, Wrangler®, are registered trademarks of the Chrysler Corporation.
M.0.R.E™, BombProof™, S.R.S.™, SlipLoc™, DoubleJointed™, RockProof™, are trademarks used by Mountain Off Road Enterprises, LLC. The
M.O.R.E.™ logo is copyright©, 1999-2007.
7686– FWK2.0 PAGE 3