Mountain Off Road JM602L User Manual
Mountain Off Road For the car
MOUNTAIN OFF ROAD ENTERPRISES, LLC.
P.O. BOX 690 DELTA, COLORADO 81416
970-625-0500
970-625-3747 FAX
E-mail:
www.mountainoffroad.com
INSTALLATION INSTRUCTIONS
for
JM602L BombProof™ MOTOR MOUNTS
Please read and understand all instructions before beginning the installation of these motor mounts. Please read
the terms and policies on the back of these instructions.
The JM602L motor mounts are a one inch lifted version of our standard motor mounts. They are designed to fit
the following Jeep® vehicles: 1991-1995 YJ Wranglers equipped with 4-cylinder engines (2.5L) ALL Jeep® VE-
HICLES USING THESE MOUNTS MUST HAVE A ONE INCH BODY LIFT INSTALLED!!! . A increase in engine
vibrations will be noticed with the 2.5 L engines!
STEP 1:
With the Jeep® on flat level ground, apply the parking brake, block the tires so it cannot move.
Put the transmission in neutral. Using a jack, place a block of wood between the jack and the oil pan. Apply a
slight amount of pressure on the oil pan. Remove the bolts holding the fan shroud to the radiator. (The shroud
should have been “lowered” one inch with the body lift kit. You will re-attach it to the “stock” location after the in-
stallation of the lifted motor mounts.
STEP 2:
Remove the drivers side stock motor mount. Save the hardware that you removed because it
will be re-used. Install the BombProof™ motor mount in it’s place. On some YJ Wrangler vehicles, we have
found that when lifting the engine, the engine mounting fork can contact the frame of the Jeep®. If this is the
case on your vehicle, modifications to the frame and or fork may have to occur. Use common sense when per-
forming this modification. Do not tighten any of the nuts or bolts at this time. If your vehicle has a aftermarket
suspension lift kit that uses spacers between the skid plate and frame to lower the transfer case, this can cause
the motor mounts to be slightly out of alignment. If you have trouble lining-up the thru-bolt, it may be necessary
to temporarily un-bolt the transmission mount from the skid plate and raise the transmission up slightly until the
thru-bolt lines up.
STEP 3:
Remove the stock motor mount from the passenger side of the engine. Install the BombProof™
motor mount in it’s place . On some YJ Wrangler vehicles, we have found that when lifting the engine, the engine
mounting fork can contact the frame of the Jeep®. If this is the case on your vehicle, modifications to the frame
and or fork may have to occur. Use common sense when performing this modification. Re-use the stock hard-
ware. Do not tighten the nuts or bolts yet. If you had un-bolted the transmission mount from the skid plate in
step 2, you can now lower it back into place and tighten the bolts that you removed.
P.S.
D.S.