Mountain Off Road WCK150 - Manual

MOUNTAIN OFF-ROAD ENTERPRISES
LLC.
P O BOX 690 DELTA COLORADO 81416
970-625-0500
970-625-3747 Fax
www.mountainoffroad.com
INSTALLATION INSTRUCTIONS FOR WCK150 SPORT CAGE
Please read all instructions, and Terms/Policies, before installing this M.O.R.E.™ product.
This Sport Cage Kit Part # WCK150 fits 1981-1986 Jeep® CJ-7 vehicles. The factory roll bar main hoop must bolt
to the floor. It will fit with hard top ( Except Steel Horse Targa Top ), or soft top, full hard doors or half hard doors
(YJ). It uses two curved bars (left & right) to attach to the factory roll bar with “connectors” that you must weld to the
roll bar. The L&R side bars bolt to these connectors. The cross bar connects the L&R side bars together just behind
the windshield frame, by slipping over the pre-welded stubs, and is secured with bolts. All necessary hardware is
provided. This Sport Cage has been designed to be as easy to install as possible. The following tools are required
for installation: welder (M.I.G. preferred), 3/8” drill bit & power drill, ratchet, 9/16” socket & wrench, level, power
grinder/sander.
M.O.R.E.™ has available several options for this Sport Cage. The Frame Tie-In Kit (# WCK101) will add to the rigid-
ity of the cage, and it requires welding to the frame. It uses a polyurethane body bushing between the sheet metal
floor and the “outrigger”. This can be added at anytime in the future.
You can add an additional Center Bar (or bars) to your cage if you desire. They are best if installed at the same time
the cage in being installed, so think about that before you install this cage! They make a great location for mounting
a C.B. radio, or stereo. The Center Bar Kit (# WCK375) bolts in, no welding. Add as many as you like, usually two
are installed.
Covered padding is available for the Sport Cage in several different lengths. Please call M.O.R.E.™ for these add-
on items.
WCK150 CONTENTS:
QTY: DESCRIPTION:
1
LEFT SIDE BAR
1 RIGHT SIDE BAR
1 CROSS-BAR
2 CONNECTOR TUBES ( 1-1/2” O.D. angle cut )
8 BOLTS-3/8”X1-1/4” ( foot-plate to floorboard )
4 BOLTS-3/8”X2-1/4” ( cross-bar & connectors )
12 CRIMP-LOC NUTS-3/8” ( foot-plate hold down, cross-bar & connectors )
8 FLAT WASHERS-3/8” USS large ( foot-plate )
4 FLAT WASHERS-3/8” SAE small ( cross-bar & connectors )
1 INSTRUCTION SHEET
Page 1 of 4
THIS SPORT CAGE IS A DECORATIVE ITEM DESIGNED FOR APPEARANCE PURPOSES
ONLY. DO NOT RELY ON IT AS PROTECTION FROM VEHICLE ROLLOVER. WEAR YOUR
SEAT BELT AT ALL TIMES. READ YOUR OWNERS MANUAL ON PROPER VEHICLE OP-
ERATION.