Synergy 5102-0X - Jeep JK Louvered Hood Panel - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
5102 JK Hood Louver Panel
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• The installation of 5102 JK Hood Louver Panel requires the use of basic hand
tools, a drill w/ ¼” drill bit, 1” and 1-3/4” hole saws and some form of metal
cutting tool. A 4-1/2” angle grinder with cut off wheel, 3” air cut off tool, or
metal cutting jig saw all work well for cutting through the hood.
• Read through all instructions thoroughly prior to beginning installation
PARTS LIST:
• 1
PPM-5102 JK Hood Louver Panel
• 24
¼-20 UNC Button Head Socket Cap Screws
• 24 ¼-20 UNC Nylock Flange Nuts
INSTALLATION:
1) We recommend removing the hood from the vehicle for the length of the
installation process, to prevent damaging any under hood components during
installation.
2) Begin by disconnecting everything that is attached to the underside of the hood.
Remove the ground strap (10mm wrench)
Disconnect the hose going to the windshield sprayer
Unplug the hood light, and remove it from the hood. Note – The
plastic push pin securing the light to the hood is a 2 stage fastener.
Pull the top part of the pin up first to allow the barb fitting to be
removed from the hood.
Pull off the insulation from the underside of the hood as well. It is
secured to the underside of the hood via 3 plastic barb fittings and
4 formed metal tabs on the hood.
Lastly, remove the two 9mm nuts securing the U-shape tie-down
point to the hood