Synergy 5205 - TJ/LJ Cage Tie-In Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
POLY PERFORMANCE MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5205 Jeep TJ / LJ / YJ Cage Tie-In Kit
Version 1.1
GENERAL NOTES:
• These instructions are also available on our website; www.polyperformance.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• This is a weld on roll cage tie in kit that is strongly recommended to be used with
our roll cage kits.
• All welding should be performed by an experienced welder with proper welding
equipment.
• This kit is designed to be used with our PPM-5203 Jeep TJ / LJ Front Cage Kit or
our PPM-5231 YJ Front Cage Kit.
1)
Installation of this Tie in Kit should be done after roll cage is tacked or fully welded
into place.
2) Once A-pillar base plates have been determined / located, mark and drill the holes
in the floor. Use the A-pillar base plate as a template and drill 4 x 3/8” - 25/64”
holes in the floor of the Jeep.