Synergy 5224-A - Jeep JK 4 Door Rear Cage Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5224-A JK 4 DOOR REAR CAGE KIT
Version 1.1
GENERAL NOTES:
• These instructions are also available on our website; www.polyperformance.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• This is a weld in roll cage kit, all welding should be performed by an experienced
welder with proper welding equipment
• Use in conjunction with PPM-5221-A; JK front cage kit
• This kit works with either a soft top or hard top
• Use extreme care when welding and grinding in the interior of your Jeep, remove
or cover any components you do not want welding spatter or grinding sparks to
damage.
1. Remove the hard top or soft top, if using a soft top, remove the door surrounds and the
entire soft top and bow assembly.
2. Remove the sound bar and unzip the rear roll bar padding.
3. Install the PPM-5221-A front cage kit per the instructions included with the front cage
kit.
4. Unzip the C-pillar cross bar padding and remove the interior lamp. Position the C-
pillar spreader bar bracket over the C-pillar cross bar. The triangle points forward
and the holes should line up with the holes in C-pillar cross bar. Cut holes in the
padding cover where the tubes will go through, you will need to notch the padding on
the bottom of the C-pillar cross bar. Mark the edges of the bracket on the cross bar.
Remove the paint for welding.
5. Position the C to B pillar spreader bars, the ends of the tubes should fit into the cutouts
in the C and B pillar spreader bar brackets. The bends in tubes should be at the rear
of the tubes.