Synergy 5501-02/04 - Jeep JK Rubicon Rock Rail Kit - Manual (Page 7)

Rockers ready to weld
9) With paint removed and ready to weld, tack weld the parts into place. Be careful
not to get any weld sparks onto the vehicle’s paint as this will damage the finish.
10) We suggest moving on to the opposite side of the vehicle at this point to match
everything left to right before proceeding.
a. Once everything is tacked in place, we recommend removing the whole
rocker guard assembly to finish installation.
b. There are three attachment points on each rocker. Each attachment point
has two 10mm nuts and one 13mm bolt securing it to the body. Remove
this hardware and pull the rockers off the vehicle.