Synergy 5716-01 - JK Diesel HD Transmission Cross Member 07+ - Manual (Page 3)

3. Next, using a floor jack/tranny jack or other lifting device, lift the weight of the
transmission off the factory cross member. It is usually easiest to lift from under the
t-case.
4. With the weight of the drive train off of the factory cross member, remove the left
side (drivers side) bolts which secure the cross member to the frame. Use an 18mm
wrench / socket for removal. Bolts 1 & 2 in Image 4.1 below.
IMG 4.1
5. Next, remove the 2 bolts attaching the factory gas tank skid to the factory cross
member. Bolts labeled #2 in Img 5.1 below. After removing the gas tank skid
hardware, loosen the 2 bolts on the passenger side which attach the transmission cross