Synergy 5801 - Jeep JK 2/4 Dr Front Grab Handle - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5801 JK FRONT GRAB HANDLE KIT
Version 1.4
GENERAL NOTES:

It is helpful when installing the grab handles to remove the front hard top section or to fold back the
front soft top section.

The grab handle kit is a bolt on installation but you do have to trim some plastic interior trim.
Parts / Tools Needed to complete installation:

13mm socket & ratchet with extension

#2 phillips screw driver

3/16” allen wrench

T-15 Torx bit / driver

1-3/8” hole saw with ¼” pilot bit and quality drill

Dremel / die grinder & file.
INSTALLATION:
1. Reference the photo below for the completed installed part before beginning.