Synergy 5803 - Jeep JK 2 Dr Rear Grab Handle Set User Manual
Synergy For the car
Advertising
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5803 JK 2 DR REAR GRAB HANDLE KIT
Version 1
GENERAL NOTES:
• It is not necessary to remove the soft top or hard top for installation but it may be
helpful
• The grab handle kit is a bolt on installation but you do have to trim some of
plastic interior trim. A dremel type tool or straight air grinder with a drum sander
works well for this.
1. Remove the seat belt turning loop (2)
2. Unzip and remove the rollbar padding from around the b-pillar and, using a trim stick
C-4755
(interior trim removal
tool) or
equivalent, separate
the
retaining clips (1) and
remove
the upper trim (2).
Advertising