Synergy 8002 - Jeep JK Chromoly Tie Rod - Manual (Page 2)

7. Install dust boot onto tie rod end and roll lower spring down to the bottom lip of the dust boot as pictured below.
8. Install the new tie rod so that the bends are flat and the tie rod is bent forward, away from the axle, the double adjuster side goes
on the driver side (left) with the pinch bolt on the back of the tie rod.
NOTE: If you are installing on a RHD vehicle, install the tie rod so the double adjuster is on the right or driver side, with the pinch
bolt on the back of the tie rod.
9. Tighten the castle nuts to 50 ft-lbs or more to align the cotter pin hole and install the cotter pins
10. Set the toe-in by turning the adjuster sleeve on the driver side to get the same toe-in that you had before. If you are taking it to an
alignment shop the factory specification is +.20 degrees +/-.03 degrees.
11. Tighten the tie rod adjuster sleeve pinch bolts to 50 ft-lbs
12. Tighten the jam nut on the passenger side very tight. Jam nuts have tendency to come loose so man up and get it really tight!
13. Install the steering stabilizer bracket and steering stabilizer