Synergy 8012-13 - Jeep JK Weld-On Front Track Bar Bracket - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8012-13 JK WELD ON FRONT TRACK BAR
BRACKET, STOCK TUBE
Version 2
GENERAL NOTES:

These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.

This track bar relocation bracket moves the track bar mounting location up by 3”.
This will give you the correct track bar mounting location to use when flipping
the draglink to the top of the knuckle or when using the Reid Racing knuckles.

The installation of this bracket requires the complete removal of the stock track
bar bracket with a sawz-all and cut off wheel or plasma cutter or oxy-acetylene
torch. The new bracket must be welded to the axle tube. An experienced
fabricator/welder is recommended to properly install this bracket.

A minimum of 3” tall bumper stop spacers are required to prevent the track bar
relocation bracket from contacting the frame when the suspension is at full bump.
1. Remove the track bar, steering stabilizer sway bar links and tie rod from the front
axle.
2. Cut off the factory track bar bracket from the axle tube.
a) Cut the top weld with a cut off wheel