Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 3)

4. INSTALL BRAKE LINES.
• Remove the stock brake lines from the frame hard line connection and brake caliper,
install the new brake lines with the new banjo washers. Install the frame bracket as
shown.
Figure 4-1
• The same brake line is used at all 4 corners, once the brake line is installed at the caliper
you can slightly bend the 90 bent tube end of the brake line at the caliper toward the
frame similar to the stock brake line.
Figure 4-2
• Wait until the rear brake lines are installed to bleed the brakes.