Synergy 8046 - Jeep JK Fixed Rear Lower Control Arms - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8046 JK HD REAR LOWER CONTROL ARMS
Version 1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• The installation of these control arms will allow you to correctly align the rear
axle after a suspension lift kit is installed.
• These arms are ½” longer than stock. This length works well when using the
stock length upper control arms and for longer upper control arms when using a
CV style rear drive line and 3-4.5" of lift. If using a CV style rear drive line and
you need the pinion pointed up towards the output on the t-case, we recommend
these arms to be used in conjunction with
PPM-8054 JK REAR ADJ UCAs for
optimum drive line angles.
1. Remove the existing lower control arms. If you are just replacing the lower control
arms, they can be replaced one at a time with the vehicle sitting on level ground,
without removing the tires & wheels or any other suspension part.
2. Install the new control arms with the bend at the axle end, and arm positioned so that
the bend in the arm is pointed down toward the axle as to provide more ground
clearance. See picture below for clarification. Reuse the factory control arm bolts.