Synergy 8057 - Jeep JK Front Bump Stop Spacer Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8057 JK FRONT BUMP STOP SPACERS
Version 1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• These bump stop spacers come in 2.0, 3.0, and 4.0” heights. Installation is the
same for all sizes.
• Installation can be done using simple hand tools and a drill with 3/8” drill bit.
1. INSTRUCTIONS
• Locate and center punch the center of the bump stops strike pad on the axle coil spring
mounts. Drill a 3/8” hole.