Synergy 8078 - Jeep JK Rear LCA Skids w/ Integrated Shock Mounts User Manual
Synergy For the car
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
INSTALLATION INSTRUCTIONS
PPM-8078 JK RHD LOWER SHOCK MOUNT
GENERAL NOTES:
These instructions are also available on our website at www.polyperformance.com
Check the website for any updated instructions and additional photos for
reference.
Note: Some cutting and grinding of the factory control arm mount is required for
installation.
Bracket is designed to be bolted on but can be welded on as well if desired.
(NOTE: If bracket is being used as a lower coil over mount, we strongly
recommend the bracket be welded on)
PARTS LIST:
2 – PPM-8078 JK R HD LOWER SHOCK MOUNT
2 – 1/2 -13 UNC bolt 2.75” long
2 – 1/2 -13 UNC stover nut
4 – 1/2” flat washers
4 – 3/8-16 UNC bolt 1” long
4 – 3/8-16 UNC stover nut
8 – 3/8” flat washers
2 – 9/16 - 12 UNC bolt 4.5” long
2 – 9/16 - 12 UNC stover nut
4 – 9/16” flat washers
INSTRUCTIONS:
1) Begin by removing the rear TB bolt and nut at the frame side (#2 in picture
below). This is easiest to do with the vehicle still sitting on the ground under
its own weight.