Synergy 8079 - Jeep JK Front Sway Bar Quick Disconnect Kit User Manual
Page 2
Advertising
4. Attach the sway bar disconnect pin as shown below, use a flat washer and nylock nut.
Orient the hole in the pin vertically. You can use a punch through the hole to hold the
pin while tightening the nut.
5. Adjust the sway bar links so both sides are the same length. Leave less than ½” of
thread showing past he jam nut. Tighten the jam nut so that the rod end stud is
parallel to the lower bushing tube.
6. Attach the end links to the anti-sway bar. Tighten the nylock nut to the rod end stud
to 60 ft-lbs.
Advertising