Synergy JK OE Replacement Drive Shaft - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
JK DRIVE SHAFT INSTALLATION INSTRUCTIONS
Version 1.1
GENERAL NOTES:
• These instruction are for the installation of 1310 and 1350 JK drive shafts, any
differences will be noted
• Front and rear procedures are the same, any differences will be noted.
• Pinion yoke torque is very critical, follow the instructions completely or you may
over crush the crush sleeve and have to completely disassemble the differential to
replace it.
• We recommend that you install a new pinion nut when replacing the pinion yoke.
New nuts are available from the dealer at a reasonable price.
• Front pinion nut: 04720895
• Rear pinion nut: 05191197AA
PINION YOKE
1. Support the axle on jack stands and remove the tires and wheels
2. Remove the factory drive shafts.
3. Using a flat head screwdriver wedged between the inner brake pad and caliper piston,
push the brake caliper piston in slightly. Slide the caliper outward so the brake pads
do not touch the rotors as to relieve any drag between the brake pads and rotors.