sPOD Source - Manual

s POD Source Installation Instructions
www.4x4s-POD.com
1
1. Attach your accessories here.
SWx Is the
Positive and GND is the negative terminals.
2. Negative battery terminal.
3. Positive battery terminal.
4. Switch panel harness input.
5. Low voltage detection circuit.
6. Low voltage detection circuit fuse. Remove this fuse to
disable LVCO
• If the LVCO detects a low voltage (10.6VDC) and
shuts the sPOD down, turn off all switches on sPOD
and start the vehicle to enable the sPOD again.
7. Accessory fuses. Any fuse can go here up to 30 AMPs. (6 pl.)
8. Relays that are removable.
Always keep your engine running
whenever possible when powering
electrical accessories
10 mm socket
12 mm socket
Auto Reset
Circuit Breaker
After installation
!!!Must start engine to activate system!!!
• Connect
Positive & Ground wire to battery terminals. Use supplied cable ties to secure all cables.
`
Run white connector up
through opening in plastic
Plug connector in with
key facing outward
2
3
8
1
7
6
4
5
+ + + + + +