Smittybilt 886308 Billet Grille (Overlay) - Manual

886308
Installation Instructions
Billet Grille (Overlay)
08-on SUPER DUTY BUMPER INSERT
PART#: 886308
TOOLS REQUIRED
- Phillips Screw Driver
- 4mm wrench
IMPORTANT NOTICE:
Carefully read the instructions before attempting to install this product. The manufacturer is in no way responsible for any
damage to the vehicle or personal injury that may occur during the installation or use of this product.
NOTE: During shipping product might loose its convex shape or the bars may bend slightly. In order to get a proper fit,
product might need to be re-shaped slightly by bending it BY HAND to regain its convex shape. Be careful not to damage
the Billet Grille when bending.
INCLUDED COMPONENTS
1 – Billet Grille(1 piece)
4 – Metal Brackets
8 – M4 x 20mm Phillips Screws
8 – M4 Flange Nuts
INSTALLATION INSTRUCTIONS
1. Inspect product and check components with items listed above.
2. Position the Bumper Billet onto grille shell cavity.
3. Loosely attach the billet grille by holding metal brackets behind factory grille shell and insert phillips screws (from
the front) through the billet grille holes and metal brackets, secure them with flange nuts provided as shown in
Figure 3.
4. Adjust billet grille to the position you like then tight the screws.
Smittybilt Automotive Products 400 W. Artesia Blvd, Compton CA. 90220
Phone 888-717-2797 Fax 310-747-3912
Figure 1 – Included Hardware
Figure 3 – Billet grille is secured on bumper
Figure 2 – Billet grille is installed