Smittybilt 17394 Bolt-On Fender Flares User Manual
Page 2
WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Bolt-On Fender Flares
Ford F150 (09-12)
Part #17394
STEP 5:
Clean the body areas where the Fender
Flares will makes contact. Use the supplied alcohol wipe.
STEP 6:
Remove four (4) 5.5mm bolts and retain for
installation of Fender Flares. For 2007-2013 vehicles,
only 3 bolts are removed.
For models equipped with factory fender flares, removal
of factory flares is required, please consult the vehicle
service manual for factory fender flare removal.
STEP 3:
Pulling at right angles to the extrusion,
remove the liner from the extrusion in small portions and
apply thumb pressure to ensure that it adheres to the
Fender Flares.
STEP 4:
Trim any unnecesary extrusion and discard.