Smittybilt FN1960 S4X SIDEBAR - Manual

Page 1 of 1 4/23/07 (AM)
PARTS LIST:
1 Passenger Sidebar 4 ½” x 2” Hex Head Bolts
1 Driver Sidebar 4 ½” ID x 1 ½” OD x 1/8” Flat Washers
1 Front Driver Mounting Bracket 4 ½” Lock Washers
1 Rear Driver Mounting Bracket 6 12mm ID x 29mm OD x 3mm Flat Washers
1 Front Passenger Mounting Bracket 6 12mm Lock Washers
1 Rear Passenger Mounting Bracket 6 12mm Hex Nuts
2 Double Bolt Plate 8 8-1.25mm x 30mm Hex Head Bolts
2 Single Bolt Plate 8 8mm Lock Washers
4 8mm Hex Nuts
4 8mm Clip Nuts
12 8mm ID x 22mm OD x 3mm Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. DO NOT ATTEMPT INSTALLATION ALONE;
PERSONAL INJURY OR DAMAGE TO THE TRUCK MAY RESULT.
2. Remove black tape and large grommets over mounting holes located on the inside of the rocker panel.
3. Mount (1) Double Bolt Plate into rear mounting holes, and (1) Single Bolt Plate into front mounting hole. Secure
them with the included (3) 12mm Lock Washers, (3) 12mm Flat Washers, and (3) 12mm Hex Nuts.
4. Attach front and rear brackets by placing bolts through holes as shown in figure below.
5. Attach Sidebar to brackets using the included (2) ½” x 2” Hex Head Bolts, (2) ½” Flat Washers, and (2) ½” Lock
Washers.
6. Repeat steps 2-5 for opposite Sidebar.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
INSTALLATION INSTRUCTIONS
SIDEBAR
04-07 FORD F-150 SUPERCREW
PART NUMBER FN1960 S4X
½” x 2” Hex Bolts,
½” Lock Washers, &
½” Flat Washers
½” x 2” Hex Bolts,
½” Lock Washers, &
½” Flat Washers
12mm Lock Washers
12mm Flat Washers
12mm Hex Nuts
8mm x 30mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Double Bolt Plate
Single Bolt Plate
8mm x 30mm Hex Bolt
8mm Lock Washer
8mm Flat Washers
12mm Lock Washers
12mm Flat Washers
12mm Hex Nuts
Driver Side Shown