Smittybilt FN1750-S4 Sure Steps - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Sure-Step (Part # FN1750-S4)
01-03 Ford F150 Super Crew
QTY DESCRIPTION
1
Side Bar, left side
1 Side Bar, right side
1 hardware kit
NOTE: Please read this information before installing. Check components received with components listed above. NO
DRILLING REQUIRED for installation of these side bars. To obtain correct installation we recommend you to follow
these step by step installation instructions carefully. Please take care when installing this product to protect the finish
and your investment.
Step One: Locate hardware and check contents with the hardware listed below.
QTY
DESCRIPTION
4
10mmx 35mm hex bolts, zinc plated GR5
4 12mm x 50mm hex bolts, zinc plated GR5
4 12mm flat washers, zinc plated
4 12mm split lock washers, zinc plated
2 10mm x 25mm hex bolts, zinc plated GR5
14 10mm hex nuts, zinc plated
20 10mm flat washers, zinc plated
14 10mm split lock washers, zinc plated
1 801155L front support bracket, left side
1 801155R front support bracket, right side
1 801160L rear support bracket, left side
1 801160R rear support bracket, right side
4 801161 backup brackets
Step Two: Locate one 801161 bracket, one 801155L support bracket, one 10 x 32mm bolt, one 10 x 25mm bolt, four 10mm
nuts, six 10mm flat washers and four 10mm lock washers. Secure the brackets to the vehicle as shown in Fig 1, 2 and 3. Do
not fully tighten hardware at this time.
Step Three: Locate one 801161 bracket, one 801160L support bracket, one 10mmx 32mm bolt, three 10mm nuts, four
10mm flat washers and three 10mm lock washers. Secure the brackets to the vehicle as show in Fig 1, 2 and 4. Do not fully
tighten hardware at this time.