Installation instructions, Src off road roof rack – Smittybilt 76715 SRC OFF ROAD ROOF RACK User Manual
Page 2
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W. Artesia Blvd, Compton, CA 90220
Installation Instructions
SRC OFF ROAD ROOF RACK
87-95 Wrangler,97-06 Wrangler,04-06 Unlimited
Part #’s 76711,76713,76715)
IMPORTANT- You are going to have to remove the bolts from your door hinge. DO NOT OPEN THE DOOR WHILE
THE BOLTS ARE REMOVED! YOUR DOOR WILL GO OUT OF ALIGNMENT.
Front Upright INSTALATION INSTRUCTIONS
1.
Place the adhesive backed gaskets on the front uprights to protect the
vehicle from scratches.
2.
Remove factory windshield hinge and lower door hinge bolts (only
work on one door at a time) It is important that you can enter the
Jeep through the opposite door to tighten the lower door hinge
without the door moving. (Figure 1).
3.
When you remove the lower door hinge a backing plate (figure 2)
will come loose. Enter the Jeep from the opposite side to access the
plate. You will need it in step 4.
4.
Using the supplied front upright 1/4x20 allen bolts and a ¾” flat washer, attach
the front upright to the Jeep. You will need a partner to place the factory
backing plate (Figure 2) for the lower door hinge in location for you to attach
the lower door bolts. (Do not open the door you are working on! Enter from the
opposite side). Tighten the bolts for the upright and repeat the process for the
opposite side. (Figure 3)
Figure 1A
Figure 1B
Figure 2
Figure 3
We recommend that two people install the SRC Roof Rack. The following instructions show a TJ, but
each step can be used on the Unlimited as well.